Influence of different etching modes on bond strength and fatigue strength to dentin using universal adhesive systems

Toshiki Takamizawa, Wayne W. Barkmeier, Akimasa Tsujimoto, Thomas P. Berry, Hedehiko Watanabe, Robert L. Erickson, Mark A. Latta, Masashi Miyazaki

Research output: Contribution to journalArticle

40 Scopus citations

Abstract

Objectives The purpose of this study was to determine the dentin bonding ability of three new universal adhesive systems under different etching modes using fatigue testing. Method Prime & Bond elect [PE] (DENTSPLY Caulk), Scotchbond Universal [SU] (3M ESPE), and All Bond Universal [AU] (Bisco) were used in this study. A conventional single-step self-etch adhesive, Clearfil Bond SE ONE [CS] (Kuraray Noritake Dental) was also included as a control. Shear bond strengths (SBS) and shear fatigue strength (SFS) to human dentin were obtained in the total-etch mode and self-etch modes. For each test condition, 15 specimens were prepared for the SBS and 30 specimens for SFS. SEM was used to examine representative de-bonded specimens, treated dentin surfaces and the resin/dentin interface for each test condition. Results Among the universal adhesives, PE in total-etch mode showed significantly higher SBS and SFS values than in self-etch mode. SU and AU did not show any significant difference in SBS and SFS between the total-etch mode and self-etch mode. However, the single-step self-etch adhesive CS showed significantly lower SBS and SFS values in the etch-and-rinse mode when compared to the self-etch mode. Examining the ratio of SFS/SBS, for PE and AU, the etch-and-rinse mode groups showed higher ratios than the self-etch mode groups. Significance The influence of different etching modes on dentin bond quality of universal adhesives was dependent on the adhesive material. However, for the universal adhesives, using the total-etch mode did not have a negative impact on dentin bond quality.

Original languageEnglish (US)
Pages (from-to)e9-e21
JournalDental Materials
Volume32
Issue number2
DOIs
StatePublished - Feb 1 2016

All Science Journal Classification (ASJC) codes

  • Materials Science(all)
  • Dentistry(all)
  • Mechanics of Materials

Fingerprint Dive into the research topics of 'Influence of different etching modes on bond strength and fatigue strength to dentin using universal adhesive systems'. Together they form a unique fingerprint.

  • Cite this